Mini Split Sub for Your Buda Projects
You need a mini split sub who shows up when the drywall crew leaves. One number for your bid, a date that holds, and an install that doesn't make you look bad at walkthrough. That's what Jester Climate delivers in Buda.
| Standard single zone install, weekday | $2,400 materials and labor |
|---|---|
| Same install, Saturday or Sunday | $2,600 materials and labor |
| Joker day | One day each week priced under the weekday rate, day shown on the home page |
| Booking deposit | $400 toward materials |
| Balance | Due on completion |
| Non standard work | Quoted before any work begins |
| Bid line item | Mini split installation, single zone, standard install: $2,400 |
| Note | Standard install: $2,400 weekday, $2,600 weekend |
| Note | Deposit: $400 to book, balance on completion |
| Note | Non-standard work quoted before start |
| Scope confirmed | At the site walk |
| Contact | (512) 297-7493 |
The Bid Line Item
Your bid needs a flat number that covers labor and materials. No hidden fees, no callbacks for missing pieces. The $2,400 weekday rate is for a standard single zone mini split install.
That number includes the condenser, wall unit, line set, electrical disconnect, and startup. If the job is non-standard, we quote it before any work begins. You know your total cost before we touch the building.
Scheduling That Holds
You pick the date. We confirm it. If anything changes on our side, you get told immediately. The install happens on the day the drywall crew is out and the rough-in is ready.
Each week there is one Joker Day priced lower than the weekday rate. Which day it lands on changes week to week and is revealed on our home page. Call to check availability.
Walkthrough Ready
Your client sees a clean install. Lines are routed tight, wall penetrations are sealed, and the units sit level. No loose wires, no exposed refrigerant lines, no mess.
We understand that a sloppy install hurts your reputation. Our crew treats every job as if the owner is standing in the room. The walkthrough is the only impression that matters.
Repeat Work, One Call
When you have multiple projects in Buda, you do not want to chase subs every time. One phone call sets up repeat scheduling across your jobs. The same crew, the same process, the same flat number.
Call (512) 297-7493 to discuss your upcoming projects. We keep a calendar and confirm dates as your builds progress.
Working in Buda
We service Austin and the I-35 corridor, including Buda. No additional travel charges for jobs within that area. The $2,400 rate is the same whether you are in Buda or downtown.
Buda builds vary from new construction to retrofits. Our standard install covers the basics. For anything unusual, we walk the site and quote before work begins.
Included in the number
- Wall unit installation
- Condenser unit installation
- Line set installation (length confirmed at site walk)
- Electrical connection to provided disconnect
- Drain line routing and connection
- Wall penetration seal
- System startup, test, and operation check
Quoted before work begins
- Line set runs beyond the pre-measured allowance (confirmed at site walk)
- Additional wall penetrations beyond one
- Custom drain routing (e.g., pump or long run)
- Electrical work beyond the disconnect (subpanel, new circuit)
- Structural modifications (beams, framing, roof penetrations)
- Ceiling cassette or multi-zone systems
Have these done before the install date and the day runs clean. Anything not on this list gets looked at during the site walk.
- Power at the disconnect location (breaker off, wire terminated)
- Clear access to interior and exterior installation areas
- Wall penetration path free of obstructions
- Condenser pad location accessible and level
- Finished surfaces protected from dust and debris
- Trash and debris removed from work area before arrival
- Arrival and site prepCrew reviews the site walk notes and confirms the install location. Floor and wall protection is laid down. Tools and materials are staged.
- Indoor unit mountThe wall bracket is secured to studs. The line set hole is drilled and sleeved. The unit is hung, leveled, and the drain line is connected.
- Outdoor unit installThe condenser is set on the pad or bracket. The line set is pulled through the wall, connected to the service valves, and the electrical whip is wired to the disconnect.
- Line set evacuation and chargeThe line set is evacuated to remove moisture and air. The refrigerant charge is released from the outdoor unit. System is leak checked.
- Startup and cleanupSystem is powered on and tested in cooling and heating modes. All wall penetrations are sealed. Work area is swept and debris is removed. Crew walks through the install with the builder or client.
Phases run in this order on a standard job. Site conditions change the pace, so nothing here is a timeline commitment. If something on site is different from the walk, you get told before it turns into cost.
$400 materials deposit books the date and buys the equipment for your job. Balance due on completion, on the visit the system runs.
$2,400 weekday. $2,600 Saturday or Sunday. One Joker day each week is priced under the weekday rate. The day moves week to week and it is shown on the home page, so if your schedule has slack you can aim at it.
Non standard work is quoted before any work begins. Nothing gets added to the number without you approving it first.
Running the same install across more than one project? Call (512) 297-7493 to set up repeat scheduling.
- What is the deposit and when is the balance due?
- The deposit is $400 to book your install date. The balance is due on completion of the install. We accept checks and credit cards at the job site.
- What if the site conditions are different from what we discussed?
- We walk the site before the install date. If conditions change after that, we quote any non-standard work before we start. You approve the cost before any additional work begins.
- How do I schedule repeat jobs across multiple projects?
- Call (512) 297-7493 and tell us you have recurring work. We set up a schedule and confirm dates as your builds progress. One point of contact for all your Buda projects.
- What is the Joker Day and how do I get that price?
- Each week one weekday is priced lower than the $2,400 standard rate. Which day it lands on changes week to week and is revealed on our home page. Call to check if your preferred date is the Joker Day.
- Do you pull permits for mini split installations?
- Permit requirements vary by jurisdiction. It is the owner or general contractor's responsibility to confirm and pull any required permits. We can provide the equipment specs needed for the permit application.
One number, one call, one line item in Buda, Texas. Standard single zone mini split install is $2,400 on a weekday and $2,600 on a weekend, materials and labor, $400 deposit to book, balance due on completion.