Mini Split Sub for Kyle Builders
You need a mini split number that fits a bid today. You need a sub who shows up on the day the drywall crew leaves. This is that sub.
| Standard single zone install, weekday | $2,400 materials and labor |
|---|---|
| Same install, Saturday or Sunday | $2,600 materials and labor |
| Joker day | One day each week priced under the weekday rate, day shown on the home page |
| Booking deposit | $400 toward materials |
| Balance | Due on completion |
| Non standard work | Quoted before any work begins |
| Bid line item | Mini split install, single zone, standard layout: $2,400 weekday. |
| Note | Standard install includes materials and labor for one indoor unit and one outdoor unit. |
| Note | Site walk confirms line set route, drain location, circuit size, and unit placement. |
| Note | Point of contact: call (512) 297-7493 for bids and scheduling. |
| Scope confirmed | At the site walk |
| Contact | (512) 297-7493 |
One Number for the Bid
Standard single zone mini split install is $2,400 on weekdays. $2,600 on weekends. Materials deposit is $400 to book. Balance due on completion.
That is the number you plug into your estimate. No add-ons unless we quote non standard work before it starts.
A Date That Holds
You pick the date. We confirm it. If anything changes on our side, you get told. No surprises.
One JOKER DAY each week is priced lower than the weekday rate. That day changes week to week. Check the home page for which day it is.
Clean at Walkthrough
Your client sees a finished install. Lines are covered. Drain is routed. Unit is level. No loose debris.
We work around your schedule. Drywall crew leaves. We arrive. No overlap needed.
Repeat Scheduling Across Jobs
One phone call sets up the next one. Call (512) 297-7493 to set up repeat scheduling across your projects in Kyle.
Same number. Same process. Same flat rate.
What the Site Walk Covers
We walk the job before the install date. We confirm line set length, circuit size, drain routing, penetration location, and equipment size.
Sizing is a rule of thumb confirmed on site. A casita reads smaller than it loads. West glass and a hot attic push the size up. The size gets confirmed on site.
Included in the number
- One indoor unit mounted on an interior wall
- One outdoor unit on a pad or bracket
- Standard line set up to confirmed length
- Condensate drain routed to a nearby drain or exterior
- Standard electrical disconnect and circuit connection
- Refrigerant charge and system test
- Jobsite cleanup and debris removal
- System operation check
Quoted before work begins
- Line set longer than confirmed standard run
- Drain pump required for uphill or long drain
- Concrete pad pour or structural bracket install
- Electrical panel upgrade or new subpanel
- Unit installation in a ceiling cassette or floor console
- Multi zone systems or custom ductwork
Have these done before the install date and the day runs clean. Anything not on this list gets looked at during the site walk.
- Rough electrical wire run to the disconnect location
- Clear path for line set and drain from indoor to outdoor
- Wall opening framed and ready for line set penetration
- Outdoor unit location clear and level (pad or bracket ready)
- Indoor unit location clear of obstructions and accessible
- Drywall and paint complete in the install area
- Power off at the panel for the circuit we will connect to
- Setup and ProtectionWe lay down floor protection and set up tools. No damage to finished surfaces.
- Line Set and Drain RunWe route the line set and drain from indoor to outdoor unit. Penetration is sealed.
- Unit MountingWe mount the indoor unit on the wall bracket and the outdoor unit on its pad or bracket. Level and secure.
- Electrical and RefrigerantWe connect the circuit, pull vacuum, and charge the system. No leaks.
- Test and CleanupWe run the system through heating and cooling modes. We remove all debris and packing materials.
Phases run in this order on a standard job. Site conditions change the pace, so nothing here is a timeline commitment. If something on site is different from the walk, you get told before it turns into cost.
$400 materials deposit books the date and buys the equipment for your job. Balance due on completion, on the visit the system runs.
$2,400 weekday. $2,600 Saturday or Sunday. One Joker day each week is priced under the weekday rate. The day moves week to week and it is shown on the home page, so if your schedule has slack you can aim at it.
Non standard work is quoted before any work begins. Nothing gets added to the number without you approving it first.
Running the same install across more than one project? Call (512) 297-7493 to set up repeat scheduling.
- What is the $400 deposit for?
- The deposit books your install date. It covers materials ordering. Balance is due on completion. Non standard work is quoted before any work begins.
- What counts as non standard work?
- Anything beyond a straight line set run, a standard wall mount, and a typical exterior pad. Long line sets, drain pumps, ceiling cassettes, or multi zone systems get quoted before we start.
- When do you need the site walk done?
- We do the site walk before the install date. We confirm line set route, drain location, circuit size, and unit placement. We size the equipment on site.
- Can you schedule across multiple jobs at once?
- Yes. Call (512) 297-7493 to set up repeat scheduling. One number for all your Kyle projects.
- Do you handle the permit?
- Permit requirements vary by jurisdiction. Confirming who pulls the permit is on the owner or the general contractor. We can provide any specs needed for that process.
One number, one call, one line item in Kyle, Texas. Standard single zone mini split install is $2,400 on a weekday and $2,600 on a weekend, materials and labor, $400 deposit to book, balance due on completion.